Menu

club knob

$5.00

Replacement or spare knobs for your flowtoys vision clubs! 

WARNING: Please ONLY use the screw that comes with the flowtoys club knob (or check Tech Spec for the specs on our screws) - other screws may be too long and may drill through the circuit board and damage the top LED. Please note that we cannot warranty your board in full if this happens.

Sold individually.

OR
  • Description
  • Tech Specs
  • Reviews
  • Description

    Features:

    • made by Henrys in Germany to flowtoys' specs
    • constructed from EVA rubber foam
    • user serviceable

    Warning about replacing club knobs:
    In order to maximize the amount of light near the knob, the screw is very short and can easily be stripped out. Please be careful to use great force when screwing the knob in (you read that right - use force). You should be pushing it in hard, while screwing so it does not act like a drill. Be sure to screw it in deeply/firmly, so it does not easily rip out during use. 

    Minimize how often you replace the screw/knob. It is not intended to be swapped out frequently. While we have had success with 20+ replacements, it will eventually wear out the hole and the club will need to be sent in for servicing.

    Please ONLY use the screw that comes with the flowtoys club knob - other screws may be too long and may drill through the circuit board and damage the top LED. Please note that we cannot warranty your board in full if this happens.


  • Screw is a #8, 3/4”, 18-8 Stainless Flat Head Phillip Self Tapping Screw, Type A

  • Write A Review For club knob

    How do you rate this product? *

    • Quality
    • Value